- #Spideroak linux command line how to
- #Spideroak linux command line driver
- #Spideroak linux command line mac
The ip command allows you to configure settings which take effect immediately – however they are not persistent and will be lost after a reboot. Temporary IP address assignmentįor temporary network configurations, you can use the ip command which is also found on most other GNU/Linux operating systems. The following section describes the process of configuring your system’s IP address and default gateway needed for communicating on a local area network and the Internet.
#Spideroak linux command line how to
The following is an example of how to view the supported features and configured settings of an Ethernet interface. network:Įthtool is a program that displays and changes Ethernet card settings such as auto-negotiation, port speed, duplex mode, and Wake-on-LAN. The set-name key can be used to change the device to the desired logical name.
#Spideroak linux command line mac
The match key is used to find an adapter based on some criteria like MAC address, driver, etc. If you would like control which interface receives a particular logical name use the match and set-name keys. Interface logical names can also be configured via a Netplan configuration. Product: MT26448 Ĭapabilities: pm vpd msix pciexpress bus_master cap_list ethernet physical fibre 10000bt-fdĬonfiguration: autonegotiation=off broadcast=yes driver=mlx4_en driverversion=4.0-0 duplex=full firmware= ip=192.168.1.1 latency=0 link=yes multicast=yes port=fibre speed=10Gbit/s
#Spideroak linux command line driver
In the example below, lshw shows a single Ethernet interface with the logical name of eth4 along with bus information, driver details and all supported capabilities. This command provides greater details around the hardware capabilities of specific adapters. Inet6 fe80::216:3eff:fee2:5242/64 scope linkĪnother application that can help identify all network interfaces available to your system is the lshw command. ip aġ: lo: mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 To quickly identify all available Ethernet interfaces, you can use the ip command as shown below. However, in some cases an interface may still use the kernel eth# style of naming. These names can appear as eno1 or enp0s25. Ethernet interfacesĮthernet interfaces are identified by the system using predictable network interface names. This document is geared toward server administrators and will focus on managing your network on the command line.
Ubuntu ships with a number of graphical utilities to configure your network devices. Multi-node configuration with Docker-Composeĭistributed Replicated Block Device (DRBD)
0 kommentar(er)
